여기에마켓 제품 :: 다스씨스템

DSP-based 3/6-axis Analog Motion Controllers

■ On-board 250 MHz DSP
■ Built-in PID with feed-forward gain closed-loop control algorithm - reducing the following error
■ Available with 3/6 encoders - providing up to 6 axes
■ 3/6 axes of ±10 volts analog command for controlling servo
■ Maximum servo update rate is less than 50μs per axis
■ Free MotionCreatorPro 2™ software for system setup
■ Firmware support function: Jogging, Contouring, E-gear (Electronic gear) and ECAM (Electronic CAM)
■ Firmware support function: Gantry mode, MPG (Manual Pulse Generator)

드라이버	메뉴얼	데이터시트	퀵메뉴얼
			-

[주문정보]
PCI-8253 : DSP-based 3-axis analog motion controller
PCI-8256 : DSP-based 6-axis analog motion controller

Accessory
DIN-68S-01 Terminal board with 68-pin SCSI-II connector with DIN socket
DIN-825-J3A0 Terminal board for Mitsubishi MR-J3S-A servo amplifiers
ACL-10568-1 cable 68-pin SCSI-VHDCI cable (mating with AMP-787082-7), 1 M

[제품소개]

DSP-based Analog Motion Controllers
The PCI-8253/PCI-8256 controllers combine a 250 MHz 32-bit MIPS processor, 12,000 logic element FPGA (Field Programmable Gate Array), I/O buffering circuitry, ADLINK softmotion, and motion control characterization software to control the position/velocity of as many as six ??10 V analog command servo axes.

ADLINK Softmotion
PCI-8253/PCI-8256 leverages ADLINK softmotion technology, 250 MHz DSP and 20 MHz encoder rate to meet faster servo update rate up to 50 ?gs/axis and control requirement in real application. PCI-8253/PCI-8256 not only realizes the gantry control with closed-loop and error handling, but also adopts the feed-forward gain to reduce speed profile following error to meet precise velocity and position control.