Feature
• Multi-Component analyzer—Up to Four NDIR Channels Plus Oxygen
• Measures from low ppm Up to 100% full scale
• Virtually unaffected by moisture interference
• Measures oxygen from 1% up to 100% via either paramagnetic or electrochemical Method
• Outputs: Voltage, Current, RS-485
• Compact size
• CE Mark

Specification
• IR Analysis Method – Non-Dispersive Infrared (NDIR)
• NDIR Components – CO, CO2, CH4, SO2, NO
• Detector Type – Microflow
• NDIR Ranges: CO 0-200 ppm 0-100%
                     CO2 0-200 ppm 0-100%
                     CH4 0-500 ppm 0-100%
                     SO2 0-200 ppm 0-10%
                     NO 0-200 ppm 0-5,000 ppm
• Range Ratio – 10:1
• Oxygen Analysis Method – Paramagnetic or Fuel Cell
• RO2 Ranges – 0-5% or 0-25% Full Scale
• Response Time (IR) – 90% of Full Scale within 30 seconds **Depending on Cell Length, Flow Rate and Time Constant
• IR Sample Cell – Stainless Steel
• Resolution – Typically 0.1% of Full Scale
• Repeatability – Better than 0.5% of Full Scale
• Linearity – Better than 1.0% of Full Scale of Factory
• Noise – Less than 1% of Full Scale Range
• Zero and Span Adjustment – Via front panel or remote
• Sample Flow Rate – 0.5 LPM
• Purge Gas Flow Rate – 1 LPM
• Outputs Available – RS-485 (MODBUS protocol), 0-1V / 4-20 mA
• Digital Inputs – 9 maximum optically isolated signals for range switching, begin auto calibration, output signal hold, reset average value
• Digital Outputs – 15 relays maximum, each is 1 form C for range ID, instrument failure, cal failure, cal in progress, high/low alarm limits,
                          solenoid valve activation, external pump on/off
• Display – Back lit LCD
• Sample Temperature – Up to 50°C, Non-condensing
• Ambient Temperature – –5 to 50°C
• Ambient Humidity – Less than 90% RH (Non-condensing)
• Fittings – ¼-inch NPT
• Power Requirements – 100 to 240 VAC, 50/60 Hz, 100 VA
• Dimensions – 5¼” H x 19” W x 15” D,
• Weight – Approximately 18 lbs. (Depending on confi guration)